Kia 396103C500 Ignition Coil Wire Harness

At the times or inspect the spark plug wires when installing new spark plugs. Unplug the wire of spark plug from igniting coil simply by twisting it boot-wise at the end. Do not take hold of it by hands. Apply same twisting technique while pulling on boot to disconnect same wire from other side of spark plug. You will find this as a white, chalky powder in rust form inside boots. Make sure you tightly affix the wire and boot to the edge of a spark plug this time. In case if it is necessary, squeeze your pliers around a metallic connector which is located inside of rubber boot on a wire so that it fits well. Once again push back into the terminal end of ignition coil where you can fit tightly both wire and boot together. Wipe each one with a cloth all along their length in order to remove dust or dirt from them. Inspect for burnt parts or cracks and bend them some places to see whether they have become stiffened with conductive substance or not. If you are changing your Spark Plug Wire Set, buy an entire set that goes with your engine so that you change them one after another without mixing up firing orders accidentally Push down firmly on the terminals against both the Ignition Coil Pack and Spark Plugs too Carefully attach using twisting motion while pressing it tight against new Spark Plug through its Boot Connector Coil Pack.