Kia 4130028035 Cover Assembly-Clutch

You can Select Your Vehicle to check if 4130028035 fits your vehicle.

To remove the clutch components, the transaxle must be removed from the vehicle, leaving the engine in place. To support the clutch disc during removal, install a clutch alignment tool through the clutch disc hub and loosen the pressure plate-to-flywheel bolts in a criss-cross pattern until all spring pressure is relieved. Inspect the flywheel and pressure plate for indexing marks and replace the pilot bearing and release bearing. Clean the flywheel and pressure plate machined surfaces with brake cleaner, lacquer thinner, or acetone and drive the new pilot bearing into the bore in the flywheel. Position the clutch disc and pressure plate against the flywheel with the clutch held in place with an alignment tool, center the clutch disc, and tighten the pressure plate-to-flywheel bolts. Lubricate the inner groove of the release bearing, place a small amount of grease on the release lever contact areas and the transaxle input shaft bearing retainer, and install the clutch release bearing. Finally, install the transaxle and all components removed previously.