Look inside the hood, unscrew the two screws in the top part of the bumper cover. Put your vehicle in the air by lifting up the front, securely placing it on jackstands, cracking loose the lug nuts on the front wheels, and removing the wheels afterward. Remove the engine under cover/splash shield. To detach the bumper cover from the front fenders, unscrew the screws found at the top rear corners, hidden on the inside of each wheel well. Undo the screws that keep the back parts of the bumper cover attached to the bottom front area of the car. Remove the bumper cover with assistance. When putting it back together, undo everything you took off earlier, then tighten the tires' lug wheel nuts to the required torque level. Lift up the taillight housings and disconnect all the screws that keep the upper bumpers in place at these same locations. Keep the vehicle stable when you lift up the back end with jackstands. Shake the rear wheel nuts, lift the car, then put the jackstands under it. Unscrew the fasteners from both the front and back edges of the wheel housings around the rear wheels. Also take them off from the bottom of the bumper cover. When installing, put the wheel lug nuts back tightly according to the exact torque rating.
