Kia 981001U000 Windshield Wiper Motor & Link Assembly

Because of this place, to replace the windshield wiper motor you first of all must unbolt the wiper arm mounting nuts that attach the wiper arms to the shafts. Subsequently, note the position of each of the wiper arms with reference to the shaft before they are removed for the necessary adjustments to be made to enable proper fitting in their correct positions. Following this, disconnect the electrical connector from the wiper motor by drawing its lower section and then pull on the upper section of the connector. Remove the mounting bolts of the wiper motor and link assembly that are secured by three bolts and disconnect the wiring of this assembly and pull out the assembly from the cowl area. Depress the snap ring on the wiper motor crank arm pivot and pull the linkage rod away to produce clearance for extracting the crank arm off the motor shaft if needed, using a screwdriver. Another bolt is needed to be unfastened for the removal of the crank arm, then with a pencil tracing exercise the position of the crank arm to that of the motor shaft is made, the crank arm is then pulled out. Subsequently, there are wiper motor mounting bolts which should be detached to free the motor from the link rod assembly; while the procedure of the assembly is conversely the process of removing. With regard to the rear wiper motor, start by taking out the rear wiper motor shaft nut; then, position the rear wiper arm before removing it as related to the motor shaft. Disengage the trim panel of the lift gate followed by the electrical connectors of the rear wiper motor control unit. Next to it, there are bolts for the rear wiper motor control unit and the motor itself; unscrew these bolts and take the motor out. Removal: removal is done systematically in a clockwise manner accompanied with care to avoid pulling the pores bei Installation: this is the reverse of the removal.