Disconnect the cable from the negative terminal of the battery. Remove the upper and lower steering column covers. Take out the driver's knee bolster panel and the reinforcement plate behind it. The manufacturer recommends removing the steering column, but access to the ignition switch screws can be achieved by lowering the column without complete removal. Disconnect the wiring, remove the screws, and take out the ignition switch from the back of the assembly. Disconnect the wiring, remove the screw, and take off the key illumination ring from the Ignition Lock Cylinder. To remove the Ignition Lock Cylinder, insert the key and turn it to the on position. Use a small pointed tool to depress the lock, then pull the lock cylinder out. Installation is the reverse of removal.