Oil changes should be done more often as the oil slowly became diluted and filled with contaminants that damages the engine over time. Initially, be sure to prepare all sorts of equipment's such as rags or newspapers for the floor. It is easier to get to the underside of the vehicle if the vehicle is raised on a hoist, ramped up or supported by jackstands; avoid working under a vehicle that is only supported by a bumper or a jack. Locate the oil drain plug, and also warm the engine so as to enhance oil draining. Park the car on a flat location; switch on the engine to warm up the car after which it has to be turned off, and the filler cap is to be removed. Lift the vehicle using jackstands and be cautious while doing this not to be injured by the falling vehicle. Put a drain pan beneath the drain plug, unscrew it using the correct socket wrench, let the old oil drain observing the drain pan for metal shavings. Following flushing, remove the drain plug as well as clean the area and replace the plug tightly, and hold the drain pan below the oil filter. Oil filter can be accessed from below; to remove, use an S-wrench and on removal do the tilting to avoid any spillage. This should involve cleansing of the block surface that is inclusive of the mounting surface so that no more of old oil or gasket is remaining. Consult the previous and the new filters, coat the new filter's gasket with motor oil, and sandwich the unit into the slot without over-tightening it. Take all the tools and rag from under the vehicle then lift it up. Insert a funnel into the filler cap and pour 3 quarts of new oil and see the level maximum on the dipstick. Engines should be warmed up for a minute, then one should tighten up the drain plug and filter if there are signs of leakage. Check the quantity of oil in the dipstick after about five to ten minutes of running the engine and supplement as the situation maybe. On the first few steerage of the boat after altering the change, consider checking the leaks and the level of oil. Get rid of the old oil in the proper method by letting it cool down and stock it for a recycling firm, do not dispose of the oil by pouring it on the ground or down the drain.
