Kia 931103K000 Ignition Switch Assembly

Disconnect the cable from the negative terminal of the battery. Remove the upper and lower steering column covers. Take out the driver's knee bolster panel and the reinforcement plate behind it. The manufacturer recommends removing the steering column, but access to the ignition switch screws can be achieved by lowering the column without complete removal. Disconnect the wiring, remove the screws, and take out the ignition switch from the back of the assembly. Disconnect the wiring, remove the screw, and take off the key illumination ring from the Ignition Lock Cylinder. To remove the Ignition Lock Cylinder, insert the key and turn it to the on position. Use a small pointed tool to depress the lock, then pull the lock cylinder out. Installation is the reverse of removal.

Disconnect the cable from the negative terminal of the battery, remove the knee bolster from below the steering wheel, and take off the instrument cluster trim panel. Then, disconnect the electrical connector to the ignition switch, remove the small screw securing the ignition switch to the housing, and take out the switch.