Do not come into direct contact with the bulb's exterior, as skin oils will cause overheating and the bulb's early demise. If there is contact it is recommended that the bulb should be cleaned with rubbing alcohol. In most models, from the year 2001 to 2006, the
Headlight housing carries the low-beam bulb, and an additional component called the combination light housing contains the high-beam bulb; however, for all these years, both bulbs are the same, and hence, both housings can be removed equally, once the headlight housing has been taken out. Start with the removal of the headlight housing and then, the cover at the rear of the unit is to be unscrewed anti-clockwise. Subsequently, it is necessary to remove the wiring and pull off the electrical connector. Pull out the retaining spring and take out the old bulb by unscrewing the spring clip touching the wire. Next, but ensuring that the fingers are gloved to avoid transferring body heat to the new bulb, fit the new bulb into the headlight housing. This is particularly true if the glass will be touched or becomes oily; clean it with rubbing alcohol before the glass is installed. Last, place the bulb retaining spring, reconnect the wires, put the cover back on, connect the wiring harness and put the headlight assembly back.