Brazen the
Headlight housing if the wiring harnesses are disconnected while performing the operation. They are located inside and can be rather easily replaced but they are better changed on a workbench when they are disassembled. Twist off the cover that is on the back of the headlight housing. Eliminate the wiring, afterwards, unclasp the spring and remove the bulb covered with a spring wire which was inserted before. Carefully, do not touch the bulb glass with the bare hand then replace the new bulb assembly into the headlight housing. Then the bulb retaining spring has been installed and wiring has been done. Last, the cover should be properly fixed, and the wiring harness connected, and the headlight assembly put back into place.