Genuine Kia Sportage Fuel Level Sensor

Kia Sportage Fuel Level Sensor Parts Questions & Answers

• Suction Plate & Sender Assembly
  311302E300
  Q: How Do I Remove the Fuel Pump and Fuel Level Sensor on a Kia Sportage?

  A: To remove the fuel pump, first, relieve fuel system pressure, remove the fuel cap, and disconnect the battery's negative terminal. For Sportage models, remove the access cover, disconnect the fuel pump connector and fuel lines, and remove the pump. To install, reverse the removal steps, reconnect the battery, start the engine, and check for leaks.
• Fuel Pump Sending Unit Assembly
  311302E350
  Q: How to Replace the Fuel Pump and Fuel Level Sensor?

  A: Disconnect the fuel pump and fuel gauge sending unit from the assembly. Loosen the clamps and remove the hose connecting the pump outlet pipe. Remove the inlet filter and the small bracket at the bottom of the pump. Remove the rubber mount and the large rubber band securing the pump. Discard the old pump assembly sealing ring and replace it. Remove the fuel gauge sending unit and disengage the ground wire receptacle. Disconnect the fuel pump electrical connector and outlet hose. Detach the wiring harness clip and pull apart the fuel pump assembly. Remove the cover, pump, rubber insulators, inlet filter, and Fuel Pressure Regulator. Install new 0-rings on the regulator. Remove the old fuel filter, regulator or sending unit, and install the new ones. Remove the rear seat cushion, carpeting, access cover, and disconnect the electrical connector. Remove the sub fuel sender from the fuel tank.