Genuine Kia Sorento Fuel Pump

Kia Sorento Fuel Pump Parts Questions & Answers

• Fuel Pump Assembly
  311104Z500
  Q: How Do I Replace a Fuel Pump/Fuel Level Sending Unit?

  A: Drain any residual gasoline from the fuel pump/fuel level sensor. Check the strainer for clogging and replace it if necessary. On 2005 and earlier models, the fuel pump can be separated from the filter/sender assembly and replaced, while on later models, the pump is not available individually.
• Fuel Pump Assembly
  311503E500
  Q: How to Remove the Fuel Pump/Fuel Level Sending Unit Assembly from the Fuel Tank?

  A: Depressurize the fuel system and remove the tank cap. Disconnect the negative battery terminal, remove the rear seat and carpet flap, and take off the fuel pump service hole cover. Disconnect the fuel pump connectors and fuel lines. For 2006 and earlier models, remove the fuel pump mounting flange bolts. For 2007 and later models, use tool #09310-2B200 or pliers to remove the lock ring. Lift the fuel pump assembly from the tank. Check the pump strainer for contamination and clean if necessary. If it's too dirty, remove and clean or replace it. Reinstall in reverse order.
• High Pressure Fuel Pump
  353202G730
  Q: How to Remove the High Pressure Fuel Pump from the Cylinder Head?

  A: Disconnect the negative battery terminal and remove the air filler housing. Unplug the fuel pressure regulator valve electrical connector and remove the ignition coil from cylinder four. Detach the canister purge control solenoid valve and fuel supply line quick disconnect fitting. Remove the nut from the high-pressure fuel pump and delivery pipe using special tool #09314-3Q100. Take off the junction block and high-pressure fuel pipe. Unscrew the fuel pump mounting bolts and remove the high-pressure fuel pump. Rotate the engine until the lifter for the pump is at the lowest point. Apply oil to the pump o-ring, set the pump on the cylinder head, and tighten the new bolts. Installation is the reverse of removal.